I haven’t done miniatures before. Printed it ultra fine detail with 0.05mm layers. This came as a kit-card with vestigial sprew work. www.thingiverse.com/thing:4679744 Fun little project. No glue required and fully articulated. For the grappling cable I use 24 gauge flower wire.
My resin printer was powered off with resin in the vat for about 7 months. Last night I turned it on, gave it a job, and I woke up to a successful print....
I’m getting increasingly frustrated trying to get my printer calibrated. I’ve done a bed calibration using screws_tilt_calculate, and that’s all nice and good. Got a bed mesh variance of 0.19mm which seems great....
🌟 Exciting News From Formnext 2023! 🌟 Get ready for the biggest 3D printing event of the year at Formnext 2023! Surprise, surprise! For the first time ever, you’ll get the chance to see our newest and latest addition to our product lineup: a FDM 3D printer!
so im a teen with not alot of money but i want to get into 3d printing, another community suggested the ender 3 original. it looks like a solid printer but who know im a noob after all. my budget is around 100$ or less. im looking into making mini figures and painting them or whatever nerdy thing i find. i know the budget is...
I’m looking at getting an airbrush kit for my prints and for my wife’s crafts. Can anyone recommend a good kit since I know nothing about it? All feedback appreciated.
I got an Ender V3 S2 a month ago to build a darksaber for my kid for Halloween. Came out looking great. No complaints. I then did a couple of upgrades (bed springs, converted to direct drive, Klipper/Mainsail rather than stock firmware/UI) and it’s a lot easier to dial in bed tramming....
I have been trying to print a print-in-place planetary gear without any luck. Today I found out about a setting that finally got it to print. Cura’s slicing tolerance -> exclusive uses the largest part of each layer to calculate the slice which can help when trying to print something with tighter tolerances. Unfortunately, the...
Gina had posted previously ( octoprint.org/…/we-need-to-talk-about-funding/ ) that she needed more support or she was going to have to stop maintaining Octoprint and get a full time job. Apparently everyone came thru!...