3dprinting

Screenshots: imgur.com/a/jp5fm3U...

Made this based on lemmy.world/post/3494325

I have every setting turned all the way up speed/accel/jerk is only limited by the power limits on the steppers. In the firmware speed is set at 300mms same with on prusa slicer. I just added zeros to the accel and jerk both in firmware and in the slicer. It’s an ender 3 with an skr V2 Rev b board and a generic 2 into 1...

cross-posted from: lemmy.procrastinati.org/post/6173...

I received a free broken CR-10S Pro V2 from my cousin, I finally have it repaired well enough to make these nice spiral vases. Here is the full album (not sure how to post albums here yet):...

I repurposed the lightning element of an Ikea Solvinden lantern to fit a custom lamp shade. The lamp was created with OpenScad with a ton of customization options :D Printed with yellow Prusament PETG

I got myself a tungsten nozzle, thinking it would last forever…...

Hey all! Super excited to see a lot of my favorite content showing up on Lemmy. I noticed that r/elegoosaturn has gone completely private on Reddit. Any chance it made it over here?

Designed in Fusion 360. Printed on an Elegoo Saturn S. Airbrushed black and finished with RubNBuff.

The large bolts are 1/2in (eq ~12mm), the smaller are M8. The lower section is expandable. There is a space between the low and mid sections that clamps the metal sheet and (mostly) prevents it from folding due to stresses from dies. There is an X beam support somewhere around here that is supposed to go on top to prevent...

Just another older project. IIRC it is a Yagi based on a thingiverse project that was based on an antenna designed by the YouTuber Andrew McNeil. I modified everything about the design and integrated the enclosure and stand. It works well enough to get a signal from my driveway when I used to have trouble just within the house.

Hey folks! I’ve been getting some odd results on my Ender 5 prints lately. It looks like the filament isn’t extruding in a regular pattern. Would someone like the offer some input on why this might be? I’d appreciate any assistance, thank you.

www.thingiverse.com/thing:6075723youtu.be/KmCcjxr04Fs...

Next step is learning to use filler, sanding, and painting

I hope the 3D Printing community welcomes other CNC tools. This is a project I made on my custom-built laser table, utilizing “Living Hinges” aka “Torsion Lattice Hinges”. They’re a really neat mechanism that allows for a variety of different arrays or “lattices” of shapes that facilitate bending–and of-course...

First post on Fedi/image post test/let’s get this community churning!...

Videos:...

In this episode, the hosts start with a PSA about backing up data and Stefan’s SSD failing. Later, Tom shares his plans for SMRRF and Stefan reveals his intention to be present at both Formnext and SMMRF in 2023. The conversation then shifts towards 3D-printed salmon meat, the Hangprinter project’s challenge to the ORNL...

UPDATE:...

This one didn’t print right but I’m gonna try it again later I might change up the color too