I haven’t done miniatures before. Printed it ultra fine detail with 0.05mm layers. This came as a kit-card with vestigial sprew work. www.thingiverse.com/thing:4679744 Fun little project. No glue required and fully articulated. For the grappling cable I use 24 gauge flower wire.
I have a Sapphire Plus printer which I have heavily modified (out of the box it is a piece of junk). After finally changing the mainboard and installing Klipper I got it to print reliably. Of course the next thing I wanted to do was print fast. It quickly became apparent that the E3D V6 hotend and the anemic 3010 fans severely...
Hello fellow withprinters. Whats happening here? Stringing is not the problem, if i print string tests, they are good. Its only in holes, the walls wont stick. Any suggestions for a fix?...
Just printed this plant pot and the quality is absolutely trash. It’s a large print (150mmx150mmx150mm) but printed using my normal settings. It’s solid wall - 4-5 perimeters thick. Sliced in Prusaslicer 2.6.1 and printed on an Ankermake M5. Any ideas?...
I am happy with the result. There is a black line accross the badge due to the head going through it, but I removed it by sanding it. Maybe I should play with the z-hop setting.
I just want to brag a bit. Printed on an Anycubic Kobra 2. Runs without much problems. At the moment 10 Days on a single winding, tweakble up to 32 days. The weight is from another wooden self build clock....
I do a lot of soldering and for the last few years have been using SMD components. Up until recently I was buying short pieces of tape with a few dozens or a hundred components. The amount that I do has really increased and running our of components began to irritate me so I started buying them on commercial rolls of 4,000 or...