3dprinting

Mouse I printed on my Photon mono 4K. SLA is a learning curve for sure! I had LOTS of failures trying to print this.

I have some Fiberology PA12+CF15 blend (link) from a long time ago and recently got around to using it. I am amazed to say the least! It prints easier than PETG, even without an enclosure. Only downside is that it is much more expensive per kg, although it is lower density so I don’t seem to be going through it as quickly as...

When you design several features you don’t need and still haven’t used…...

This system can be adjusted and securely locked in place. This example is a M42 2mmp. A printed tool fits the clamp collar outer spline to adjust tension on a bicycle crank while the base is attached to the crank spindle....

The #3DBenchy model usually capsizes in water, but I found that with the right slicer settings, it will actually float upright: www.thingiverse.com/thing:6076719

I printed this a while back and is by far the most useful and fun thing ever.

Here’s a close up picture of the print itself: imgur.com/a/flJjhGs. It’s printed in PETG with 40% infill. I printed it first in PLA, but then it snapped immediately (thankfully not on my face). The only reason why I didn’t use PETG from the get go was that I actually didn’t know you could print it without an enclosure....

Still going through my included bottle of resin, they sent me flesh color. This is my first venture into resin printing. Ive been FDM printing for years now, have a few Ender 3s....

Just finished building this beast. It’s a ratrig Vcore 3.1 with a 500x500x500mm build volume and blazing speed.

So tried out some PETG for the first time, and the first couple prints went really well. but I believe it's picked up quite a bit of moisture, sitting in the basement....

printables.com/…/224383-astronomical-telescope-ha…

First post on Fedi/image post test/let’s get this community churning!...

Here is my 3D Printing Setup. Anyone else on Lemmy Interested in 3D printing?...