I have been trying to print a print-in-place planetary gear without any luck. Today I found out about a setting that finally got it to print. Cura’s slicing tolerance -> exclusive uses the largest part of each layer to calculate the slice which can help when trying to print something with tighter tolerances. Unfortunately, the...
Gina had posted previously ( octoprint.org/…/we-need-to-talk-about-funding/ ) that she needed more support or she was going to have to stop maintaining Octoprint and get a full time job. Apparently everyone came thru!...
I’m considering pulling the trigger on an X1C but the waste is a huge turn-off. I know there are options for purging to infill or a sacrificial object, but last I heard there’s still a considerable amount of purge/prime. Can someone who’s played with the settings tell me honestly how much progress has been made in reducing...
Hello fellow withprinters. Whats happening here? Stringing is not the problem, if i print string tests, they are good. Its only in holes, the walls wont stick. Any suggestions for a fix?...
Just printed this plant pot and the quality is absolutely trash. It’s a large print (150mmx150mmx150mm) but printed using my normal settings. It’s solid wall - 4-5 perimeters thick. Sliced in Prusaslicer 2.6.1 and printed on an Ankermake M5. Any ideas?...
Hi everyone, I figured I have struggled with this enough over the past day and its time to consult the community. I’ve been running this same setup for about a month now with the only major change in that time being implementing the input shaping. Recently (last week) I have been unable to complete any prints because every...
In this episode, the hosts start with a PSA about backing up data and Stefan’s SSD failing. Later, Tom shares his plans for SMRRF and Stefan reveals his intention to be present at both Formnext and SMMRF in 2023. The conversation then shifts towards 3D-printed salmon meat, the Hangprinter project’s challenge to the ORNL...
I am happy with the result. There is a black line accross the badge due to the head going through it, but I removed it by sanding it. Maybe I should play with the z-hop setting.
Hey there! As a 3D printer addict I do a lot of small parts in CAD to print and use around the house. Lately I’ve been exploring all sorts of CAD software since finding out there’s a more around than just Fusion360 and Onshape so I started exploring what’s out there and jotting down my impressions....