Small latch for cabinet, little door, to attach something to other thing. Works well also as printer test. Gap between parts is 0.2 mm. Can be printed fully working on place without supports as shown on video. If you have problems with movement most likely problem is stringing. https://youtu.be/MCwRCMNyMc4
This adaptor is to connect 1 1/4in hose to 1 1/4in hose. I've used 2x R-20 o-rings and it seems to seal well or you can use Intex 1.25in Dia Hose Seal.
Similar to a previous design (https://www.thingiverse.com/thing:6088152), but much better ventilated. I'd been wanting to use a Voronoi pattern in a project and discovered an online resource for converting 3d models into printable "Vorinated" bodies (https://www.voronator.com/). The site has its limitations, but it's free and...
Updated20230727 Someone send me feedback that the snap place is too tight and hard to separate, so I modified all 4 models, you can try the new one. Updated: Someone said the angle of the hanger is not good, it might form a bad shade of the clothes, so modified the angle, you can download the"Foldable Hanger_angle" and"Foldable...
My wall power outlets at home do not have a center screw. Some 6 way splitters have a center hole so you can secure it to the outlet such that it won't pull away when you unplug something....