I’ve printed about 40 rolls of iiidmax PLA+ and have encountered bulges like these before. I thought it was just bad luck but I think I’m done now. Going to try to finish the 10 rolls I still have left and find a new brand.
Printed this a while ago on my Ender 3 Pro. Took forever but came out pretty well.
Scaled this guy up 270% to just about 12" tall. Printed each piece separately and took me a long time even on the X1C. Then it took some more time figuring out how to glue it together. Unfortunately it looks like the author removed it from thingiverse.
Prints started to get all wonky about a week ago. I couldn't figure out the problem. Changed the nozzle, tighten the belts, lubed the z screws, and cleaned the carbon fiber rods. Disassembled the extruder and I didn't see any clogging, but when I disassembled the hall sensor, I noticed a lot of wear. Then I found a piece of...
When I run the Power Delete Suite, it runs and tries to edit but I noticed most comments are not edited. I tried updating a comment manually while it’s running and it gave me...