I’ve printed about 40 rolls of iiidmax PLA+ and have encountered bulges like these before. I thought it was just bad luck but I think I’m done now. Going to try to finish the 10 rolls I still have left and find a new brand.
I've tried to warn people about them. I got a 10 pack early on while learning and it almost made me give up the hobby. Classic n00b mistakes? Some, but after I set that filament aside in a drybox, I had almost no problems. The only mistakes I made with those other brands were due to strategies I developed to rescue prints from IIIDMax's garbage. I must have used 10-20 other brands over the next year, revisiting the cursed spools occasionally.
I thought I could relegate the leftovers to my 3D pen. Somehow that satan-spawned plastic jammed it up. The pen is basically a soldering iron, a motor, and 2 gears. I've fed strips of PETG bottles cut by hand through it. The filament wasn't precise enough for my no precision 3D pen.
It’s the cheapest PLA that I could find at about $10 / roll, made in the USA, ships pretty quickly, and nearly all rolls print without issue. But this is the second time I’ve seen a bulge like this, so it’s not bad luck. There’s some quality control issues.
I would contact their customer support, is likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.
I would contact their customer support, it’s likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.
I would contact their customer support, it’s likely they’ll send you a new roll, and hopefully it will help them improve quality knowing they shipped some bad ones.
Add comment