I will build a plastic enclosure for it then. I prefer not to put it back in the box so this is great.
Didn’t know what brim or mouse ears were so I’ll try that, thanks. I also received the file before slicing where it was standing with the small bottom as the base so I made it flat. The software was going wonky in snap so I might have not given it a flat spot. Would it have been better not to go flat and print it with the skinny side down? I thought it would fall over. Picture a wall plaque app. 70mm x 40mm x 4mm and it was presented as the 40mm x 4mm as the bottom and build up the 70mm.
I had a fan near it, oops. I will try the brim.
Thanks a lot for all of the advice. I have the whole day to work on stuff so I’m preparing my files and having a blast.